BLANCOBENT UF

Bentonite for use during crossflow filtration

BLANCOBENT UF is a highly purified powdered bentonite allowing for 1-step
protein stabilization and crossflow filtration.

• Compatible for direct dosing into symmetrical hollow fiber membrane crossflow systems
• Powdered formulation is free of crossflow damaging sand and grit
• Does not cause excessive abrasion to crossflow membranes due to the lack of large, abrasive particles (<100 μm)
• Can be prepared in room temperature water
• Always consult your crossflow manufacturer prior to use (approved for use for use with Pall Oenoflow system)
• Not recommended for use on wines that will not be crossflow filtered - use FERMOBENT PORE-TEC or NACALIT PORE-TEC depending on goals
• Contact Time: During crossflow

---

Recommended Dosage: Bench trials recommended

• Wine: 200–2000 ppm – 20–200 g/hL – 1.6–16.8 lb/1000 gal

Usage: Usage: Add BLANCOBENT UF to wine up to 12 hours prior to crossflow filtration. To prepare BLANCOBENT UF: add slowly to approximately 10 times its weight of room temperature water under constant stirring. Allow a rest period of 30-60 minutes, then stir again thoroughly. Let the mixture swell for 6–12 hours. Dispose of supernatant and add remaining bentonite slurry to the wine while thoroughly mixing.
Storage: Dated expiration. Store in a dry, odor-free and well-ventilated environment below 25°C (77°F). Reseal opened packaging immediately.

---